FoxESS Community - Owners & Installers Forum

It turned out that the new comms data cable (the short interconnect one) was faulty.

All working now.

Do we know the latest Firmware ver for BMS and batteries?

Mine showing BMS as ver 1.004 but I was informed are being updated to 1.14 if I heard correctly.

Thanks

Many thanks Dave. I appreciate your kind input.

PS
FoxCloud 2.0 battery page shows
Version_BMS 1.004

It only lists master and three slavers.
The serial number for the new (fourth)battery isn’t listed

And the inverter page shows

Version_Master 1.65
Version_Slaver 1.02
Version_ARM 1.74

Are these in need of update?
I have my fingers crossed ...

Thank you,

Photo attached..
I have carefully checked and the addr dip switches all have the on label correct orientation.

I have raised a support ticket to request a check / firmware upgrade.

Jason Feeky - did you eventually resolve your problem? What was the issue eventually identified / the solution?

Yes. Existing batteries were close to 50

44percent.

Hello,
I wonder if someone has any suggestions please.
I had a new instal in April. With BMS and 3 x Mira HV25 2.45 batteries.

I decided to add another battery. Went for Mira HV25 again.

Bracket and battery installed all ok.
All connected exactly as the foxess YouTube video shows. Dip set to ...

Thank you very much Dave.
Your knowledge and guidance is greatly appreciated.
I will keep an eye on things.

Hello.
I wonder if someone would be able to give some advice please.

I have been getting these same error messages. “Error code 64 DC Bus volt is high”. Wondering if ok.

Apologies if I do not have the right terminology.
I had installed on Weds (scaffold is still up)
16x Longi 430W Panels 6 ...