Page 2 of 2
Re: Grid Pressure/Push back Setting added to the K and H1-gen2
Posted: Mon Jun 09, 2025 11:18 am
by AlanHarwood
I have two KH10.5 inverters.
Does the Grid Pressure/Push back setting have to be the same on both, or is it sufficient to simply change it on the Master inverter?
Re: Grid Pressure/Push back Setting added to the K and H1-gen2
Posted: Mon Jun 09, 2025 12:11 pm
by Will
Good result all the same.
Re: Grid Pressure/Push back Setting added to the K and H1-gen2
Posted: Mon Jun 23, 2025 7:08 am
by Chapeau
Dave Foster wrote: ↑Wed Feb 12, 2025 8:13 pm
It’s not available through the inverter menu’s, only an installer level account can access this remotely.
I've just found this in the v2 of the web site
https://www.foxesscloud.com/v2/login
Devices / Select Inverter / Device Details / Settings / BasicParameters2 / MeterCompensation
I set to -50, octopus real time app shows -30, so it's about 20W out.
Re: Grid Pressure/Push back Setting added to the K and H1-gen2
Posted: Tue Jun 24, 2025 7:04 pm
by Will
great result, thanks for sharing the update.
Re: Grid Pressure/Push back Setting added to the K and H1-gen2
Posted: Thu Jun 26, 2025 7:29 pm
by alexls
Chapeau wrote: ↑Mon Jun 23, 2025 7:08 am
I set to -50, octopus real time app shows -30, so it's about 20W out.
Just had my firmware updated and now the PV's lower than usage I can test it. Set mine at -30 based on the above and I'm hovering between -6W and -11W, so similar results.