No CT clamp out regulated by HA
Posted: Sat Jun 29, 2024 12:46 am
Well to install a CT clamp in my house to the inverter is going to be a massive job
Instead I thought about linking the fox H1 to HA
Via 485 to ethernet, so the H1 can talk to the fox if that's possible
Then get ha to monitor the meter(which it does via mqq) and when in negative to zero that power by generating, that amount
Then telling it to charge during the 12-6am
Thoughts
Any one done the same
Thanks
Martin
Instead I thought about linking the fox H1 to HA
Via 485 to ethernet, so the H1 can talk to the fox if that's possible
Then get ha to monitor the meter(which it does via mqq) and when in negative to zero that power by generating, that amount
Then telling it to charge during the 12-6am
Thoughts
Any one done the same
Thanks
Martin