Page 1 of 1
Fox Hardware board.
Posted: Fri Oct 14, 2022 10:38 am
by EcoJones
Hi Will, would you mind if I make a request
It would be nice if there was a specific board for Fox Hardware and within that board could be 2 categories "Batteries" and "Inverters".
I would like to start a cube thread and wasn't sure where to start it.
Thanks.
Re: Fox Hardware board.
Posted: Fri Oct 14, 2022 10:49 am
by Will
Great idea, i've created a hardware category and broken out each battery inverter type as a sub-board. you should see it now.
Keep the ideas coming.
Re: Fox Hardware board.
Posted: Fri Oct 14, 2022 11:32 am
by EcoJones
That's great Will, many thanks.
I will post in there later today.
Re: Fox Hardware board.
Posted: Fri Oct 14, 2022 11:36 am
by Will
Most welcome
Re: Fox Hardware board.
Posted: Sat Jan 28, 2023 11:41 am
by Can
Will,
Would you consider a dedicated topic to can bus communications? This would bridge both battery (agnostic) and inverter and may suit its own section.
The reason for the request is to reach out to other techs and devs who would be interested in patching many of the new V2 issues that have been reported.
The V1 protocol is already well known in private and this could be a good place to share this information and map the newer features of V2.
Re: Fox Hardware board.
Posted: Wed Feb 08, 2023 7:52 pm
by Will
Hello,
I've created the Can bus forum here
viewforum.php?f=34
Can wrote: ↑Sat Jan 28, 2023 11:41 am
Will,
Would you consider a dedicated topic to can bus communications? This would bridge both battery (agnostic) and inverter and may suit its own section.
The reason for the request is to reach out to other techs and devs who would be interested in patching many of the new V2 issues that have been reported.
The V1 protocol is already well known in private and this could be a good place to share this information and map the newer features of V2.
Re: Fox Hardware board.
Posted: Thu Feb 09, 2023 7:20 am
by Can
Much appreciated.