FYI A number of people have reported that old / disabled schedules got activated & run after performing a firmware update. So as well as checking the CT setting, it's probably worth also checking the mode scheduler to confirm that it is in the expected state.
Site Admin
I've seen a number of reports of this also. so agree a one time manual check and reapply seems to solve it.
Community Admin / FoxESS Elite Professional
Did I help you? Feel free to leave me a tip
Book a zoom meeting for remote consultancy or help
Switch to Octopus and earn £50
Subscribe to my YouTube channel
2 x KH Hybird Inverters (Parallel Mode)
1 x H1 Gen1 (Solar Mode)
1 x H1 Gen2 WL (Testing, Modbus and API development)
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
2 x EV's (Tesla & Mercedes)
Heatpump & Low Carbon Housebuild
Did I help you? Feel free to leave me a tip Book a zoom meeting for remote consultancy or help Switch to Octopus and earn £50 Subscribe to my YouTube channel2 x KH Hybird Inverters (Parallel Mode)
1 x H1 Gen1 (Solar Mode)
1 x H1 Gen2 WL (Testing, Modbus and API development)
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
2 x EV's (Tesla & Mercedes)
Heatpump & Low Carbon Housebuild